SAT scatterplots and lines of best fit
A scatterplot shows how two quantities move together. A line of best fit turns that pattern into predictions, and its slope and intercept have real meanings.
These are the concepts this skill rests on, the same pages as in the lesson.
Reading Two-Variable Data
Each Point Is One Subject Measured Twice
A scatterplot shows two measurements for each subject, whether that's a person, a day, or a tree. Each point is one subject: how far across it sits gives one measurement, and how far up gives the other.
Read across first, then up, and name each number with its axis title. The blue point is a player who practiced 6 hours a week and made 14 free throws: the ordered pair . Swapping the two numbers is a favorite wrong answer, so read the axis titles before you read the point.
A line graph is the same picture with the points joined in order, usually over time. Only the points are real readings; the segments just connect one reading to the next.
Direction: Positive, Negative, or None
The direction of an association is the way the points run from left to right.
- Positive association: the points rise to the right. Bigger values across go with bigger values up.
- Negative association: the points fall to the right. Bigger values across go with smaller values up.
- No association: the points show no trend up or down.
To check, compare the two ends: in a positive association, points on the left tend to sit lower than points on the right. A few points can break the pattern; direction describes the overall trend.
Form and Strength
Direction is one way to describe a cloud of points. Form and strength are two more, and a question usually asks about just one of them.
- Form: linear (the points follow a straight path) or nonlinear (they follow a curve).
- Strength: how closely the points follow that path. Points close to the path make a strong association; points spread far from it make a weak one.
The first two plots rise at about the same rate, yet one is strong and one is weak. The only difference is the spread. So strength is not steepness: a nearly flat trend can be strong if the points hug it, and a steep one can be weak. Judge strength by how tightly the points cluster around the trend, never by how steeply it rises.
Average Rate of Change
The average rate of change between two points is the change in the up-value divided by the change in the across-value:
From year 0 to year 4 the club gained 20 members, a rate of members per year. From year 4 to year 5 it gained only 10, but in just 1 year: 10 members per year. The bigger change is not always the bigger rate. When the intervals are different lengths, divide each change by its own length before you compare. On a single graph, the steeper segment has the greater rate.
The Line of Best Fit
A Line of Best Fit Is a Model
A line of best fit is a line drawn through the middle of a scatterplot to model the trend. It usually misses most of the points: it runs through the middle, with the points above it balancing the points below.
The line is the model; the points are the data. So a question about "the line of best fit" or "the model" is asking about the line, and one about "the data" or "the student who…" is asking about a point.
If no line is drawn, sketch one yourself. Follow the trend, and keep points on both sides of it along its whole length, not just at the ends.
The Slope From Two Points on the Line
To find the slope of a drawn line, pick two points on the line where it passes exactly through a gridline crossing, and pick them far apart. Don't use data points; they're usually off the line.
Read the values off the axis numbers instead of counting boxes. Here one box is 1 across but 10 up, so counting boxes would give , which is wrong.
Choosing an Equation: Sign, Intercept, Size
To match an equation to a scatterplot with no line drawn, check three things in order. Each check usually knocks out at least one choice.
- Sign. Points that fall to the right need a negative slope; points that rise need a positive one.
- Intercept. Sketch the trend back to the vertical axis (where ). Here it meets the axis near 50.
- Size. Read the rise over a long run. Here the trend falls about 35 over 10, a slope near .
So fits. A choice like swaps the slope and the intercept; has the wrong sign.
Changing the Units Changes the Equation
If the data are recorded in different units, the scatterplot looks the same, but the numbers on the axis change, and so does the equation.
- Multiply every -value by : the slope and the intercept are both multiplied by . Feet to inches multiplies by 12: .
- Multiply every -value by : the slope is divided by , and the intercept stays the same. If changes from hours to minutes, every is 60 times as large, so becomes .
To check either rule, convert one point on the old line and make sure it lands on the new line. The green point in feet is in inches, and .
Predictions and Residuals
Predict From the Line, Not From a Point
A predicted value comes from the line of best fit. With an equation, plug in the given . With a graph, go up from to the line, then across to the vertical axis.
At , the line is at 14, so the model predicts 14. The data point at sits at 18: that's an actual value, not a prediction. Answer choices love to offer the nearest point's value, so don't take the bait.
With the equation , the same prediction is .
A Residual Is Actual Minus Predicted
A residual tells you how far a point sits above or below the line:
- A point above the line has a positive residual: the model predicted too low. The point has .
- A point below the line has a negative residual: the model predicted too high. The point has .
Always subtract in that order and keep the sign. Predicted minus actual gives the right size with the wrong sign, and that's a popular wrong answer.
Slope and Intercept in Context
The Slope Is a Predicted Rate
The slope of a line of best fit is the predicted change in for each increase of 1 in , with both units.
Here the slope is 3: each extra week, the predicted height goes up 3 centimeters. A correct answer choice gets three things right:
- Predicted. The line describes the trend, not every plant. "Each plant grows exactly 3 cm a week" is wrong.
- Units, in order: centimeters of height per week, not weeks per centimeter.
- Direction and size. A negative slope is a predicted decrease. Over 5 weeks the predicted change is cm, not 3.
The Intercept, and When It Means Nothing
The intercept of a line of best fit is the predicted -value when . It can be a real starting amount, such as a plant's predicted height on the day it was planted.
It means something only when is inside the data's range, or close to it. These data cover adults aged 20 to 60, so the intercept (200 milliseconds at age 0) comes from stretching the line far past the data. Nobody that age was measured, so here the intercept has no real meaning, and that's what the right answer choice will say.
Choosing a Model
Same Difference or Same Ratio
When goes up in equal steps, the -values tell you which model fits.
- The same difference each step (add the same amount): linear.
- The same ratio each step (multiply by the same factor): exponential.
Check the differences first: , . Then the ratios: , . A table that keeps rising, but by different amounts, is not linear. This test needs equal steps in ; if the -values skip around, compare steps of the same width.
In a word problem, the same amount each year (adds $500) is linear, and the same percent each year (grows 4%) is exponential. Careful: a percent of a quantity, such as 6% of , is just , and that's linear.
Reading an Exponential Model
An exponential model is . The number is the value at , and is the factor for each step of 1.
Here : it starts at 20 and is multiplied by 1.5 each step, giving 30, 45 and 67.5.
- Growth: . Growing 50% each step means .
- Decay: . Losing 20% each step means .
The base is never the percent itself: growing 50% is not , and losing 20% is not .
A Curve That Turns Is Quadratic
Points that rise and then fall, or fall and then rise, fit neither a line nor an exponential model. They fit a quadratic model, whose graph is a parabola.
In vertex form, :
- If the curve opens down (rises, then falls), is negative; if it opens up, is positive.
- The turning point, the vertex, is . Here it is near , so the model is .
Watch the sign inside: a vertex at gives , not . The full algebra of quadratics is in Skill 09: Nonlinear Functions.
Exponential Growth Eventually Passes Linear Growth
A linear quantity adds the same amount each step. A growing exponential quantity multiplies, so the amount it adds keeps getting bigger.
The line starts at 100 and adds 30 a year. The curve starts at only 40, but it grows 20% a year: it adds 8 in the first year and more every year after. After about 14 years it passes the line, and it stays above it from then on.
This is always true: a growing exponential quantity, with a positive start and any growth rate above 0, eventually passes any linear one, whatever their starting values. To find roughly when, graph both and see where they cross, or compare values in a table.
Graph and , where is the yearly growth rate. Start with , the 20% curve above: they cross near . Set : the curve grows more slowly, but it still catches the line, now near . A smaller growth rate only makes you wait longer.
What a Model Cannot Tell You
Past the Data, a Prediction Is a Guess
A model is only trustworthy over the range of data it was built from. Using it far outside that range is called extrapolation: you're assuming the trend keeps going, and nothing in the data shows that it does.
These puppies were 2 to 10 months old. At 40 months the line predicts 170 pounds, but puppies stop growing, and data that end at 10 months can't show that. A prediction far outside the data's range is less reliable than one inside it. Answer the question that's asked: if it wants the model's value, compute it; if it asks how much to trust that value, say it's unreliable because it's outside the data.
An Association Is Not a Cause
An association, even a strong one, does not show that one quantity causes the other. Something else may drive both, or the cause may run the other way.
Fires that get more firefighters tend to do more damage. That's not because firefighters cause damage: a bigger fire brings more firefighters and does more damage. To show that one variable causes another, you need an experiment that assigns subjects at random (Skill 16: Evaluating Statistical Claims). From a scatterplot alone, the right answer keeps the association and drops the cause.
Keep going
Build the basics first
Foundations has free readiness checks and lessons in the English and math the SAT expects.
Check Your Skills, the strategy for each kind of question, worked examples and practice from Easy to Hard are in the Quaero SAT Course.
More Problem-Solving and Data Analysis
Ratios, rates and units
Set up ratios and proportions, work with rates, convert units by cancelling them, and recognize proportional relationships.
Read the concepts →SAT essentials · MathPercentages
Learn what a percent means, find shares of a total, and apply one percent change or several in a row.
Read the concepts →SAT essentials · MathOne-variable data
Find the mean and median, read dot plots, histograms and box plots, compare spread, and see how one value changes a data set.
Read the concepts →SAT essentials · MathProbability
Find a probability as a part over a whole, combine events, read two-way tables, and handle conditional probability and independent events.
Read the concepts →SAT essentials · MathSample statistics and margin of error
Tell a sample from a population, build an interval from an estimate and its margin of error, see why sample size matters, and scale results up.
Read the concepts →SAT essentials · MathEvaluating statistical claims
Tell observational studies from experiments, and see what random selection and random assignment each allow a study to conclude.
Read the concepts →